Safety operation rules for self-propelled scissor aerial work vehicles
1. You must go through formal training and obtain an operation certificate approved by the relevant department before operating the aerial work vehicle; any unlicensed, illegal or illegal operation will be severely punished.
2. The aerial work platform must be led by a special vehicle or a special person in a designated driving place, otherwise it is not allowed to drive.
3. The use of aerial work platforms must be approved by employees above the supervisor level.
4. Safety warning fences or signs that are not less than 1.2 times the operating radius must be added in the working area and possible moving areas to prevent objects from falling from heights.
5. This machine is not insulated and does not provide protection against electric shock when touching or approaching electrical wires. When using an aerial work vehicle, you should pay attention to the danger of electric shock, and do not use any battery or charger greater than 48V to start the engine; Do not use it during welding use the machine as a ground wire.
6. Beware of strong winds or gusts in consideration of operating platform movement, wire swinging or slack. If the machine comes into contact with live wires, move away from the machine. Persons on the ground or on the platform must not touch or operate the machine until power is removed.
7. The personnel, equipment and materials on the platform shall not exceed the maximum carrying capacity of the platform 340Kg, which can accommodate 2-3 personnel. (This rule is based on the fact that the boom can only be raised or extended when the machine is on firm, level ground)
8. Do not use the platform controls to release the platform when it is tripped, stuck, or otherwise obstructed by attachments that prevent its normal movement. If the platform is to be released using the ground controls, it must be done after all personnel have left the platform.
9. When working in windy conditions, a hand-held anemometer must be used to measure the wind speed. Do not raise the boom when the wind speed exceeds 12.5m/s; if the wind speed exceeds 12.5m/s after the boom is raised, lower the boom and do not continue to operate the machine.
10. Do not operate the machine during strong or gusty winds. Do not increase the surface area of the platform or load. Increasing the area exposed to wind will reduce the stability of the machine.
11. In the stowed state, use extreme caution and reduce speed when the machine is driving on uneven terrain, with gravel, unstable or smooth surfaces, near openings and steep slopes, etc.
12. Do not change or disable limit switches; do not push or pull anything outside the platform.
13. Please put down the guardrail entrance of the working platform before operating the aerial work platform, and do not stack sundries on the working platform; wear a safety helmet and corresponding labor protection equipment during operation, and wear a seat belt during operation; it is forbidden to work Sitting, lying, standing or climbing on the platform.
14. When driving or operating the machine, pay attention to the sight range and the existence of blind spots; when turning, when grabbing the platform guardrail, beware of the danger of crushing.
15. Do not use damaged or faulty machines; identify the icon of the operating handle and the correct command direction when operating.
Beliebte label: 8 m self-propelled scissor aerial work platforms, China, manufacturers, suppliers, factory, customized, buy, cheap, for sale, made in China
